This post covers 14 concepts from the Pharmaceutics and Dosage Forms chapter of the RRB Pharmacist syllabus. Each concept has the key points, a worked example, a memory trick and an exam tip. Points tagged with a year were asked in that RRB paper.
Hard Capsule Sizes
Bigger number, smaller capsule. This reverse rule is asked again and again.
- Sizes run 000, 00, 0, 1, 2, 3, 4, 5.
- 000 is the largest, 5 is the smallest standard hard capsule.
- Size 1 holds about 0.5 mL.
- Size 0 holds about 0.68 mL and size 000 about 1.37 mL.
Capsule Basics
Same shell idea, different fill. Know what goes inside which capsule.
- Hard capsules are made of gelatin, an animal protein.
- Vegetarian substitute for gelatin is HPMC (hypromellose).
- Soft gelatin capsules hold liquids, oils or suspensions. Glycerin or sorbitol keeps the shell soft.
- Capsules are polished with sodium chloride, PEG or a clean cloth.
- Enteric coating (CAP, HPMCP, Eudragit L/S) dissolves only above pH 5.5 to 6, so the drug skips stomach acid.
Tablet Excipients
Every ingredient in a tablet has one job. Match the job to the name.
- Diluent adds bulk: lactose, MCC, starch.
- Binder makes granules stick: PVP, gelatin, starch paste.
- Disintegrant breaks the tablet in fluid: starch, croscarmellose, sodium starch glycolate.
- Lubricant cuts die-wall friction: magnesium stearate, stearic acid, talc.
- Glidant improves powder flow: colloidal silica, talc.
Powder Flow: Carr's Index and Hausner Ratio
Three numbers tell you if a powder will fill the die smoothly.
- Bulk density = mass / bulk volume. Tapped density = mass / tapped volume.
- Carr's index % = (Tapped - Bulk) x 100 / Tapped.
- Hausner ratio = Tapped density / Bulk density.
- Angle of repose = tan inverse of (h / r). Smaller angle means better flow.
- USP scale: Carr up to 10 is excellent, 11 to 15 good, 16 to 20 fair, above 38 very, very poor.
Tablet Defects and Tests
Capping, sticking, mottling. Each has a cause and a cure.
- Capping or lamination: trapped air or too many fines. Cure: pre-compression, less fines, more binder.
- Sticking or picking: damp granules or rough punch. Cure: dry the granules, add lubricant.
- Mottling: uneven colour. Cure: better dye and mixing.
- Orange peel in coating: poor atomisation. Cure: finer spray nozzle, slower spray rate.
- Friability loss must be below 1 percent.
- Disintegration: uncoated 15 min, film-coated 30 min, enteric no change in 2 h acid.
Monophasic Liquid Orals
Syrup, elixir, linctus, draught. One line each.
- Syrup: concentrated sucrose solution, about 66.7 percent w/w. Self-preserving.
- Elixir: clear, sweet, hydro-alcoholic solution.
- Linctus: thick sweet cough preparation, sipped slowly and not diluted.
- Draught: one or two large doses, about 50 mL, in a single container.
- Tincture: alcoholic extract, 1:5 or 1:10.
- Gargle and mouthwash are not swallowed.
Colours, Sweeteners and Preservatives
Small excipients, steady marks.
- Tartrazine is a yellow dye (E102). Sunset yellow gives yellow-orange.
- Amaranth is red, erythrosine pink-red, indigo carmine blue.
- For a children's syrup use a water-soluble food dye, never metal powder.
- Natural colours: carotenoids, caramel, cochineal, chlorophyll, anthocyanin, turmeric.
- Saccharin is a non-caloric sweetener.
- Parabens disrupt the microbial cell membrane. Benzyl alcohol is a neutral preservative.
Suspension vs Emulsion
Two biphasic liquids. Their stability problems are different.
- Suspension: insoluble solid in liquid. Shake before use.
- Emulsion: two immiscible liquids held by an emulsifier.
- Reversible: flocculation in suspension, creaming in emulsion.
- Irreversible: caking in suspension, cracking in emulsion.
- Cracking cannot be fixed by shaking.
- Emulsifier works by lowering interfacial tension.
Stokes' Law
One formula that explains why creams separate and suspensions settle.
- v = 2 r squared (rho1 - rho2) g / 9 eta.
- v is rate of settling or creaming. r is particle radius. eta is viscosity of the outer phase.
- Smaller particles settle slower. Radius is squared, so size matters most.
- Raise viscosity or reduce density difference to slow settling.
Emulsion Ratios and HLB
Primary emulsion ratios and the HLB ladder together make easy marks.
- Primary emulsion oil : water : gum. Fixed oil 4:2:1, volatile oil 2:2:1, mineral oil 3:2:1.
- HLB 1 to 3 antifoaming. 3 to 6 w/o emulsifier. 7 to 9 wetting agent.
- HLB 8 to 18 o/w emulsifier. 13 to 15 detergent. 15 to 18 solubiliser.
- Span 80 about 4.3 (w/o). Tween 80 about 15 (o/w). SLS about 40.
- Maximum phase volume ratio is about 74 percent.
Posology: Child Dose Formulae
Learn what sits in the denominator.
- Young: age / (age + 12) x adult dose, for 1 to 12 years.
- Dilling: age / 20 x adult dose, above 4 years.
- Fried: age in months / 150 x adult dose, below 1 year.
- Clark: weight in lb / 150 x adult dose.
- BSA rule: child BSA / 1.73 x adult dose. Most accurate.
Routes of Administration and Controlled Release
Which routes skip the liver and what makes a good controlled-release design.
- Buccal, sublingual, rectal and nasal routes avoid first-pass metabolism.
- Rectal route helps when the patient is vomiting.
- Hyaluronidase breaks hyaluronic acid and spreads a subcutaneous injection.
- OROS osmotic pump gives zero-order controlled release.
- Drugs absorbed by active transport at one site (methotrexate, riboflavin) are poor sustained-release candidates.
- Food can change rate and extent of absorption.
Aerosols, Liposomes and Microcapsules
Delivery systems in one card.
- Aerosol: container, valve, actuator, propellant, concentrate.
- HFA 134a and 227 replaced CFCs. Surfactants keep suspensions uniform.
- Lung deposition best at 1 to 5 micrometres.
- SUV 20 to 100 nm, LUV 100 to 400 nm, MLV above 400 nm.
- Proliposomes use fine NaCl or sorbitol powder as carrier.
- Coacervation microencapsulation: three phases, deposit coat, rigidise coat.
Parenterals, Isotonicity and Packaging
Injection basics and glass types.
- 0.9 percent NaCl and 5 percent dextrose are isotonic.
- Hypotonic fluid swells RBCs. Hypertonic fluid shrinks them (crenation).
- Pyrogens are bacterial endotoxins. Tests: rabbit test and LAL test. Dry heat 250 C for 30 min destroys them.
- Type I borosilicate glass is preferred for parenterals.
- Child-resistant packs follow the Poison Prevention Packaging Act (USA).
Practise this chapter
Attempt timed questions on Pharmaceutics and Dosage Forms and check your answers with explanations at Pharma Insights Academy.
Join RRB Pharmacist courseOpen test series